Subscribe to get special offers and be the first to know when new products get released.
10mm Stacked Band Pin
No reviews
$199.95 - Free Shipping
In addition to our heavy duty Short Stack Weight Pins, we are now offering the best solution to adding more than just additional weight or chains. With the 10mm Stacked Band Pin, you can utilize bands on your weight stacks to add a whole new level of resistance training. Complete with 21lbs of magnet pull to ensure a tight and secure fit on your weight stacks.
With our smaller rod at ~1.5", you can insert each band pin into the desired pin hole on both sides of the stack without them interfering with the guide rod inside. This allows you to move the stack freely from a lower position and utilize the heavier weight stack below to keep the bands in place.
Don't have access to the back side of the weight stack? That's ok! Place one band pin above your selector pin and leverage the bottom band pin to get your resistance going.
Not only can you utilize these band pins for the resistance of bands, but you can double them up as adder pins. Weighing in a 2.5lbs each, utilize these pins for those pesky plateaus and make incremental gains the right way. They can even accommodate additional weight* up to approximately 20lbs.
Sold in pairs.
Specs and Features
SOLD IN PAIRS
Hard Chrome includes both pin and rod
Barbell Sleeve: 3″ long with 2″ diameter, fitting Olympic weights
Six-Shooter magnets with 21 lbs of pull
Rod Diameter: 10mm
Rod Length: ~1.5" to allow use on both sides of a weight stack
Microloading makes a great adder weight for physical therapy and medical rehabilitation
Weight: 2.5lbs
*Max Weight: 25lbs depending on the type of weight stack you have
Made in USA
100% USA Steel
Bare Steel pins ship in 3-5 business days
Cerakote pins ship in 3-5 weeks
Hard Chrome ships in 3-5 weeks
Pins with TiN rods ship in 3-5 weeks
Custom pins ship in 4-6 weeks
Custom Logo Pins ship in 3-5 weeks
Laser Engraving ships in 3-5 weeks
Worldwide shipping available*
*international orders may be subject to import fees
Custom Logo Decal
We are now offering custom logo decals for your Stacked Weight Pin. The upgrade comes with 10 decals. Here’s how the process works:
Purchase your pin and add on the custom decal
Send us an email to info@baresteelequipment.com with your logo. Preferred formats are .png, .ai, .pdf, .svg or .eps
We will send back a draft for you to approve
NOTE: all artwork MUST contain the Bare Steel Equipment text and/or skull design
Approved logos take 2-3 weeks to arrive
Laser Engraving
We are now offering laser engraving on our pins. This eliminates the need for a front decal and will feature the Bare Steel Equipment Skull logo and the text along either the side of the pin or along the rod. Because of the requirement for hanging during the drying phase for Cerakote, a small hole will be drilled at the end of the pin rod to accommodate this. This will not affect the use of the pin.
Please allow 3-5 weeks for completion.
UPS Ground Shipping Time
CAUTION:
The Stacked Weight Pin is intended to be used as anadder weight or for band pin use attachment only.
It is important to check and verify the weight capabilities of your cable machines prior to use. Failure to do so may result in serious injury.
*NOTE: It is important to measure your selector pin or stack hole for the most accurate fit. A digital caliper will provide the most precise fit and are inexpensive and very convenient to have. You can find them onAmazon. If unsure of fit, measure first.