These pins have small scratches or small "chips" from the machining, developed light/moderate rust, cracked magnets, or minor finish flaws. They are considered #2 products, but their function and purpose remain just as sturdy as the #1 products. These are sold at a 15% discount. All sales are final on this item and no returns/exchanges are accepted.
The Stacked Weight Pin is a patent pending pin that allows you to add additional Olympic weight plates to any selectorized machine. The pin is a steel pin surrounded by another 2" of steel for a super strong, sturdy hold for additional plates. Magnets at the base of the pin provide 18 pounds of pull to keep the pin attached to the weight stack. The stacked weight pin is unique in that it is a 2-in-1 pin. With a weight of 5lbs or 2.5lbs, it automatically acts as an adder weight when you are in between the traditional 10lb stacks. Gone are the days of lost adder weights at the gym sticking plates to the side in awkward ways. You are sure to increase your own training and continue to challenge yourself with the Stacked Weight Pin.
Olympic Plate Size: 6" long with 2" diameter, fitting Olympic weights
Pin Size: 10/8 mm pin will fit virtually any commercial size cable selectorized machine
Weight: 5lbs - 8mm/10mm
Weight 2.5lbs - Short Stack
Max Weight: 135 lbs - 10mm/Short Stack
Max Weight: 100 lbs - 8mm
Made IN USA
The Stacked Weight Pin is intended to be used as an adder weight attachment only. Do not use the pin as a selector pin with added weight. It could cause bending of the pin and result in serious injury.
It is important to check and verify the weight capabilities of your cable machines prior to use. Failure to do so may result in serious injury.
*NOTE: It is important to measure your selector pin or stack hole for the most accurate fit. A digital caliper will provide the most precise fit and are inexpensive and very convenient to have. You can find them onAmazon. If unsure of fit, measure first.